|
Tru-Tronics
International
In spite of increasing
automation, in general, cable harnesses
continue to be manufactured by hand, and
this will likely remain the case for the
foreseeable future. In part,
this is due to many different processes
involved, such as: |
-
Routing wires through sleeves
-
Taping with fabric tape, in particular
on branch outs from wire strands
-
Crimping terminals onto wires,
particularly for so-called multiple
crimps (more than one wire into one
terminal
-
Inserting one sleeve into another
-
Fastening strands with tape, clamps or
cable ties
Free Quote Form
|
 |
|
It is clearly difficult to automate these
processes. Our qualified staff tests
the electrical functionality of each cable
harness with the aid of a test board.
The circuit diagram data are pre-programmed
into the test board, where harnesses can be
tested.
|
Tru-Tronics
International
Bus:
(702) 656-3974
Toll
Free: (888) 809-5019
|
